Identifying a user job

Use this board to ask questions or have discussions with other Genie users.
Post Reply
jac53
Experienced User
Posts: 170
Joined: Mon Jul 19, 2010 2:40 pm
First Name: Jorge
Last Name: Cabrera
Company Name: Lennar Corp
Phone: 305-229-6400
Contact:

Identifying a user job

Post by jac53 »

Does Genie have a setting which allow to identify a user job?
Like in green screen WRKUSRJOB USER(JDOE) .
User avatar
David
Profound Logic Staff Member
Posts: 690
Joined: Fri Jan 04, 2008 12:11 pm
First Name: David
Last Name: Russo
Company Name: Profound Logic Software
Contact:

Re: Identifying a user job

Post by David »

You can continue to use the same command. The user sessions run in standard 5250 interactive jobs, and WRKUSRJOB will turn them up just the same.
jac53
Experienced User
Posts: 170
Joined: Mon Jul 19, 2010 2:40 pm
First Name: Jorge
Last Name: Cabrera
Company Name: Lennar Corp
Phone: 305-229-6400
Contact:

Re: Identifying a user job

Post by jac53 »

Does that also apply for PROFOUND UI?
User avatar
David
Profound Logic Staff Member
Posts: 690
Joined: Fri Jan 04, 2008 12:11 pm
First Name: David
Last Name: Russo
Company Name: Profound Logic Software
Contact:

Re: Identifying a user job

Post by David »

If you are not starting the sessions through Genie, there is not a very easy way to find them directly, unfortunately.

This is because the jobs are not interactive, but started through the http server, in this case. All jobs under the http server start of with user profile QTMHHTTP and the current user of the job is then changed to whoever has signed in.

But, all of the IBM commands (WRKUSRJOB, etc.) work with the job start user profile, rather than the job's current user profile, and so can't be used to find these jobs.

If you are using V5R4 or higher, the system does display the current user profile on the WRKACTJOB screen, so you can find them using:

WRKACTJOB SBS(QHTTPSVR) JOB(PROFOUNDUI)

And then paging through to find the user's job(s). But, there is not a way to show ONLY the user's jobs (at least to my knowledge) using built-in IBM commands.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests